Publicidad
Idiomas disponibles
Idiomas disponibles
are occupied by persons not capable of leaving the room on their
own, unless constant supervision is provided.
Overview of the components
1. Display control
3. Fins
5. Bottom support foot
Installation
A. - Foot assembly
Before using the heater, the feet must be fitted to the unit.
1 -
As shown in the right figure,
align the holes of the support-
ing screw with the holes of the
heater body.
2 -
Finally use 2 screws (1 for each
hole) to lock and tighten the
feet.
B. - Wall assembly
Please note that the product must be installed at least 15 cm from the floor and
50 cm from the ceiling.
1 - Attach the 4 mounting brackets on to the rear of the heater using
the 8 small screws provided, ensuring that they are all orientated
so that the large hole in the bracket will be at the base of the
heater when mounted.
2 - Measure the distance between the wall hanging holes A and B on the rear of
the heater. Then measure the distance between A and C.
3 - According to the measurements size, drill 8mm diameter holes in the wall and
then insert the provided anchors in the holes.
Note: Before drilling, make sure that there are no wires or pipes located in the
wall to prevent damage.
4 - Take the long screws out of the accessory bag and fix them on the wall, screw
head exposed 5~10mm.
Instructions for use
2. Air outlet
4. Main power switch (back)
English
3
Publicidad
