Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning metal grease filters
These can be washed in the dishwasher, and need to be
cleaned w henever t he S 1 L ed c omes o n o r a t l east o nce e very 2
months o f u se, o r m ore f requently i f u se i s p articularly i ntensive.
Resetting the Grease Filter Alarm
• Turn the Lights and the Hood off.
• Press T3 and hold for at least 3 seconds, until LED flashes
three times in confirmation.
Cleaning the Filters
• Open the Panel.
• Remove the Filters one at a time, pushing them towards
the back of the unit and at the same time pulling downward.
• Wash the Filters without bending them, and leave them to
dry completely before replacing. (If the surface of the filter
changes color as time goes by, this will have absolutely no
effect on the efficiency of the filter itself.)
• Replace the grease filters, taking care to ensure that the
handle faces forward
• Close the Panel.
• 4 Filters - 48" model, 3 Filters - 36" model.
Replacing Activated Charcoal Filter
They cannot be washed or regenerated, and must be changed
when led S1 starts to flash, or at least once every 6 months.
The Alarm signal, if it has been activated, only appears when
the Hood Blower is turned on.
Resetting the alarm signal
• Turn the Lights and the Hood Blower off.
• Press T3 and hold for at least 3 seconds, until LED flashes
three times in confirmation.
Cleaning the Filters
• Open the Panel.
• Remove the Metal Grease Filter.
• Remove the saturated Activated Charcoal Filters, as
indicated (A).
• Fit the new Filters, as indicated (B).
• Replace the Metal grease filters.
• Close the Panel.
Lighting unit
• LED lights must be replaced by Faber factory authorized
service.
28
A
B
Publicidad
