PACLITE Equipment TR-800D Manual Del Operador página 8

other, Pull the recoil starter handle until engine resistance is felt, then let starter return.
5. Taking care not to pull the starter rope fully out, pull the starter handle briskly.
6. Repeat until the engine fires.
7. Let the engine run at idle for a few minutes to warm up.
8. After the engine has warmed up, the machine is ready for operation.
9. Move the throttle lever to the high speed 'H' position quickly to prevent damage from occurring to
the clutch. The 'Full Throttle' position of this machine has been preset at the factory to achieve
optimum machine performance.
10. With the engine running in the full throttle position, the machine will move forward and compact
loose 'lifts'
11. In preparation for stopping the engine, move the throttle lever to the LOW position.
12. Allow the engine to idle for 1-3 minutes.
13. Set the engine switch to the OFF position. Do not touch the HOT engine part at this time.
14. Close the fuel cock.
15. Pull the recoil starter slowly until you feel resistance. Then release your hand from the starter
knob to set it back to its original position. This will prevent any air or humidity from entering into
the cylinder.
Should you have any queries please refer to the engine operator's manual.
Model
TR-800D
DO NOT alter this setting since irregular vibration or damage to the gear
transmission mechanism can result, and both engine and machine warranties
will be automatically voided.
CAUTION
8
Engine
Hatz IB20
Yanmar L48
Maximum RPM
Optimum
3,600
3,600
Upper Limit
3,600
3,600