Publicidad
Idiomas disponibles
Idiomas disponibles
• Step 03: Then, we will proceed to fix this
part to the ceiling. Use a drill to make
the holes on the ceiling according to the
fan size. Assemble the bracket on the
ceiling using the appropriate screws.
Make sure it is well fixed.
• Warning: the screws supplied are
designed to be used on wooden
beams and concrete ceilings. Keep
the previously loosened screws of the
bracket in the same position, so that the
fan body can be mounted later. (Pic. 3)
• Step 04: We will now proceed to connect
the cables coming out from the ceiling
to the motor leads coming from the
fan body. To make the process easier
you may want to get somebody´s help
to hold the fan lifted while you do the
pertinent electrical connections, since
the receiver is integrated inside the fan
body. Connect the cables coming out
of the ceiling using the circuit board
located on the receiver. Connect the
phase wire to L and the neutral wire to
N. If there is an earth wire coming from
the ceiling connect it to the correct
socket in the terminal block (pic.4). See
picture 05 on page 7.
• Step
05:
Once
connections have been finished, we will
put the fan on the ceiling bracket. To do
this, alight the slots on the top part of
the fan with the screws in the ceiling
bracket which you have previously
loosened in the first step, and insert
them in the same position they were
originally (pic. 5)
• Step 06: Then, turn the fan body until
the screws are fitted in the correct
position. Then tighten the screws. (pic.
6).
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
Remote control connection:
See picture 05 on page 7.
L : AC IN 220-240V
N : AC IN 220-240V
all
the
electrical
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 4 hours.
Remote control:
See picture 07 on page 8.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
5. Fan ON/OFF button: Press it to turn
the fan on or off.
6. Light ON/OFF button: Press it to turn
on the lights of the device.
7. Buttons 1 to 6: Press these buttons to
set the fan speed, with 1 being the
lowest and 6 the highest.
8. Winter/summer
Press the button to activate the
winter function or to return to the fan
function (summer mode).
9. LED RGB: Press to turn on and off the
RGB lights. This button will only turn
them on or off.
10. Down button: Press this button to
decrease the light brightness.
11. Up button: Press this button to
increase the light brightness.
12. White / neural light button
13. Warm light button
14. Cold light button
15. Natural wind mode button: press it to
activate the natural wind mode
16. 1H: Setting for the fan to turn off
automatically after one hour of
operation.
17. 4H: Setting for the fan to turn off
automatically after four hours of
operation.
In order to be able to use the ceiling fan
EN
function
button:
29
Publicidad
