Descargar Imprimir esta página

Bosch TWK 78 Serie Instrucciones De Uso página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 40
en
Congratulations on purchasing this
Bosch appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1  Kettle (with water level indicator)
2  Lid with lock
3 Lid release button
4  ON/OFF O switch, illuminated
5  Limescale filter (removable)
6  Base
7  Cable tidy
Important: Use the kettle 1 only with its 
included base 6.
● Only fill the kettle with water. Milk and 
instant beverages will burn and damage 
the appliance. Never operate the kettle 
1 without water and do not overfill it; 
observe the 0.5 and max markings. If the 
kettle is too full, the water will boil over! 
Before using
for the first time
  ● Remove any stickers or film.
  ● Unroll the right amount of cable from the 
cable tidy 7 and plug it in.
  ● Fill the kettle 1 with water. Bring the water 
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is 
clean for normal use.
  ● When the water comes to a boil for the 
first time, add a tablespoon of white 
vinegar.
8
Boiling water
  ● Fill the kettle with fresh water through the 
spout or the open lid 2 (press lid release 
button 3).
  ● Read the quantity on the water level indi-
cator. Do not fill with less than 0.5 litres or 
more than 1.7 litres of water!
  ● Close the lid 2 until it locks and place the 
kettle 1 on the base 6.
  ● Press down the switch 4; the switch lights 
up. The water is heated.
  ● The kettle switches off automatically once 
the water has boiled.
The appliance can also be switched off 
at any time by pulling up the ON/OFF O 
switch 4.
Warning: If you remove the kettle 1 from 
the base and replace it before the heating 
process is over, the kettle will continue to 
heat the water. 
N.B.: Only operate the kettle with the lid 2 
closed and the limescale filter 5 inserted, 
otherwise the kettle will not switch off.
For physical reasons, the base 6 may 
collect some condensation water. This is 
normal; it does not mean that the kettle 1 
leaks.
After boiling, let the kettle cool down for 
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1 
is empty, otherwise the overheat control will 
engage and the appliance will switch itself 
off automatically.

Publicidad

loading