Beamz MHL820 Manual De Instrucciones página 5

SLND - This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press ENTER. Either
"MAST", "SL 1", or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, press
ENTER to confirm.
NOTE: In a Master/Slave configuration you can set one fixture to Master and
then set the next fixture to "SL 2", the fixtures will now have contrast movement
to each other.
SHND - Show modes 0-8 (Factory programs). Show mode can run with or
without sound active mode active.
1. Press the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between 0-8. Use the UP or
DOWN buttons to find your desired show.
3. When you have found your desired show press ENTER, then press and hold the
MENU button for at least 3 seconds to activate. After you have set your desired show, it
can be changed at any time using the UP or DOWN buttons
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select
"ON" to activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SENS - In this mode you can adjust the sound sensitivity.
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust
the sound sensitivity. 0 being the least sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
DNST - This mode can be used as a precaution mode, that in case the
DMX signal is lost, interrupted, or power is lost, the operating mode
chosen in the setup is the running mode the fixture will go into when the
DMX signal is lost. You can also set this as the operating mode you would
like the unit to return to when power is applied.
1. Press the MENU button until "DNST" is displayed, and either "MASL", "BLND", or
"LAST" will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons
to choose an operating mode you would like the unit to start up in when power is applied
or the DMX signal is lost.
• LAST - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is
applied and this mode is set, the unit will automatically go into the last DMX set up.
• MASL (Master Slave) - If the DMX signal is lost or power is applied, the unit will
automatically go into Master Slave mode and run a built-in show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go
into standby mode.
3. Press ENTER to confirm your desired set up.
DIND - This will let select your desired dimmer curve.
1. Press the either the MENU button until "DIND" is displayed, press ENTER. 1 of 5
dimmer curves will be displayed. "STDA" (standard), "STGE" (stage), "TV" (TV), "ARAL"
(theatrical), or "THAL" (Architectural).
2. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER
to confirm and exit.
ENTER
MODE
UP
DOWN
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
5