Berner BHFB 05/12V EVO Instrucciones De Uso página 9

(EN)
Operating Instructions
High-Frequency-Charger BHFB 05/12V EVO
INTRODUCTION
Thank you for your trust and decision of buying this advanced battery
charger BHFLSeries. To charge Lead-Acid Batteries (Acid, gel, AGM)
and energy supply while servicing. This digital controlled switch
mode charger is the state of art of the Battery Chargers technology.
Please, follow the operating instructions to guaranty the correct and
efficient operation for long time.
Please, read the Operating Manual with attention and follow all
instructions before putting the equipment in operation.
IMPORTANT SAFETY INSTRUCTIONS
• Save these instructions – This manual contains important safety
and operating instructions for BHFB 05/12V EVO battery charger/
maintainer.
• Use BHFB 05/12V EVO Chargers only on 12 volts lead acid, AGM
and gelled electrolyte (gel-cell) batteries. Do not attempt to use on
other voltages and types of batteries (dry cell, nickel cadmium, nickel
metal hydride, etc.) commonly found in small home appliances. This
may cause chargers and batteries to burst, resulting in damage or
injury to person and property.
• Do not expose BHFB 05/12V EVO Chargers to direct sunlight, rain
or snow.
• Do not use BHFB 05/12V EVO Chargers on batteries that are in use
or that are installed. If necessary to remove batteries from the vehicle
and take to a properly installed BHFB 05/12V EVO Chargers location.
• Do not use attachments with BHFB 05/12V EVO Chargers that are
not recommended. Nonrecommended attachments may result in
injury, electric shock, or fire and voids the warranty.
• To reduce risk of damage to electric plug and cord, pull by plug
rather than cord when disconnecting charger.
• An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in a risk of fire and
electric shock.