Stanley E-SG 4000 Traducción Del Manual Original página 12

G
B
SG 5500
Generator type:
Protection type:
Continuous rated power Prated (S1):
Maximum power Pmax:
Rated voltage Urated:
Rated current Irated:
Frequency Frated:
Drive engine design:
Single-cylinder forced air-cooled 4-stroke OHV
Displacement:
Fuel type:
Tank capacity:
Engine oil:
Consumption at 2/3 load:
Weight:
Guaranteed sound power level LWA:
Power factor cos φ:
Power class:
Max. temperature:
Max. altitude (above mean sea level):
Spark plug: TORCH/LD/LG/SX F7RTC/F7TC/F6TC
Operating mode S1 (continuous operation)
The machine can be continuously operated with the
quoted power output.
Operating mode S2 (temporary operation)
The machine may be temporarily operated with the
quoted power output. Afterwards the machine must be
stopped for a while to prevent it from overheating
5. Layout (Fig. 1-7)
1 Tank indicator
2 Fuel cap
3 230 V~ socket-outlets
4 400 V~ socket outlets (only for SG 5500)
5 12 V d.c. outlet (not for E-SG 2200)
6 Earth connection
7 Overload cut-out
Synchronous
3* 230 V~ / 400 V ~
1x12 V d.c.(8.3 A)
Normal unleaded petrol
o
Appox.1.1 l (15W40/<0 C: 5W30)
1451g/h
8 Voltmeter (not for E-SG 2200)
9 Oil drain plug
IP 23M 10 Oil filler plug
3.6 kW 11 Oil shortage cut-out
5.5 kW 12 On/Off switch
13 Choke lever
14 Pull cord
5.2 A 15 Electro starter (only for E-SG 4000, SG 4200 and SG
50 Hz 5500)
16 Petrol cock
17 Wheels (only for SG 3000, SG 4200 and SG 5500)
3
389 cm 18 Carry handle
19 Rubber feet (not for SG 2200, E-SG 2200 and E-SG
25 l 4000)
20 Battery (only for SG 4200 and SG 5500)
21 Transport handles
87 kg 22 Oil filler set
97 dB(A) 23Spark plug wrench set
1 24 Push bar assembling set ( not for E- SG 2200, E-SG
G1 4000 and SG 2200)
40 °C 25 Wheel assembling set ( not for E SG 2200, E- SG 4000
1000 m and SG 2200)
26 Spanner
27 DC oulet adapter cable
28 Air filter set
29 Spark plug
30 Muffler
31 230 V~ / 400V ~transfer switch ( for SG 5500 only)
32 Transport handle fixing knob ( not for E-SG 2200, E-SG
4000 and SG 2200)
33 Electro starter key
6. Before putting the machine into operation
6.1 Wheel assembly (only for SG 3000, SG 4200 and
SG 5500, fig. 8-10)
1. First place one end of the bolt (item 25) through the
hole in the frame and secure it with a nut and washer.
2. Put the socket through the another end of bolt (item
25) and place the wheel, washer and secure it with the
nut.
3. Place the wheel cover and secure it via clip as
designed on the inner side of cover.
12