Publicidad
Idiomas disponibles
Idiomas disponibles
How to mount and connect the WRF
Mount the receiver on a flat surface. Follow the next steps.
1.
Insert a slotted screwdriver to the niches at the bottom of the receiver and remove the backplate.
2.
If required, set the receiver number in the panel bus using the DIP switch. See figure below. If 2 or more receivers are installed, set
the number of receivers in the panel (Technician->System Settings->Peripherals->Wireless Peripherals->Global Settings).
Note: This applies for panel version 1.5 and up, and WRF version 18.2F and up.
3.
Pass the four bus wires (not supplied) through the back plate and mount the plate.
4.
Connect the bus wires using the supplied connector. Connect the wires according to the numbering on both the control panel and
the receiver's terminals (no. 1 on the control panel connects to no.1 on the receiver, etc.).
5.
Set the receiver in the control panel (see how in the Programming guide) and check the LEDs; see below.
6.
Click the receiver into the back plate.
7.
Test the receiver using the
Label Color and State
Run
Green 1 blink
Bus
Red blinks
Rx
Red 1 blink
Red 2 blinks
Ordering information
• WRF143 P/N: 8500030
Tests and Diagnostics
menu.
Description
Device OK
Valid communication (FORCE bus)
Reception - unregistered device
Reception - registered device
• WRF187 P/N: 8500041
-2-
Receiver number setting
DIP switch
3
2
1
3
2
1
1
ON
2
Publicidad
