GRE RBR75 Manual De Instrucciones página 7

TROUBLE SHOOTING
If you have problems with your cleaner, follow the troubleshooting steps below to restore performance.
Note: turn off the power before making any repairs.
PROBLEM
The robots fails to suck
up debris.
The robot stops moving
in the middle of the
pool (the rotating head
is still turning).
The robot cannot cover
the entire pool or move
along the walls of the
pool.
The robot moves slowly. The debris chamber is full.
The turning head does
not rotate or is clearly
rotating slowly.
POSSIBLE CAUSES
The battery is low.
Impeller stuck.
The impeller is damaged.
The debris chamber is full.
The robot was stopped by an
obstacle.
The robot has been blocked by
the suction of the main pool
floor drain.
The ground is not totally flat
The debris chamber is full.
The operation time was shorter
than expected.
The water circulation generated
by the filtration system
interrupts the direction of
movement.
The wheel is stuck.
The bottom of the swivel is
stuck.
The debris chamber is full.
SOLUTION
Then charge the robot.
Turn off the power supply of the robot and
visually check whether the impeller rotates.
If necessary, contact your dealer for further
instructions. Warning! Before servicing the
equipment, make sure that the robot is
turned off.
Please contact your dealer for replacement.
Clean the glove box and filter cover.
Check the cleaner for obstructions.
Remove obstacles.
Turn off the filtration system (see
instructions in the manual).
It takes more minutes before moving again
or Make the bottom of the pool flat or trim
the bottom brush strip. Contact your dealer
for replacement parts.
Clean the glove box and filter cover.
Clean the filter chamber and recharge the
robot for 4-5 hours
Turn off the filtration system (see
instructions in the manual).
Check and remove debris from the wheels.
Clean the glove box and filter cover
The glove box is full, check and remove any
debris that may be stuck under the rotating
head. It can be rotated by hand and rinsed
with water until smooth.
Clean the glove box and filter cover.
EN