Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Line in REEL-EASY
Head
See Figures 10 - 11.
Use .095 in./2.4 mm diameter monofilament line.
1. Stop the engine and disconnect the spark plug wire.
2. Cut one piece of line approximately 25 ft. (7.6 m) in
length.
3. Rotate knob on string head until line on knob aligns
with arrows on top of string head.
4. Insert one end of line into eyelet located on either side
of the string head and push until line comes out through
eyelet on the other side. Continue to push line through
the string head until the middle section of the line is
inside the string head and line outside the string head is
evenly divided on each side.
5. While holding the string head in one hand with your
other hand, rotate the knob on the string head clockwise
to wind the line. Wind the line until approximately 8 in.
(203,2 mm) remains protruding from the string head.
Maintenance
WARNING:
Use only Toro replacement parts when servicing
this product. Use of any other parts could create
a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
16
String
™
Line
Rotate
Clockwise
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off engine, wait for all moving
parts to stop, and disconnect spark plug wire
and move it away from spark plug. Failure to
follow these instructions can result in serious
personal injury or property damage.
WARNING:
Periodically inspect the entire product for dam-
aged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasten-
ers and caps and do not operate this product
until all misssing or damaged parts are replaced.
Please call 1-866-574-9242 or contact an autho-
rized service center for assistance.
Arrows
Figure 10
Eyelet
Figure 11
Operation / Maintenance
Publicidad
