Putting The Pool Cleaner Into The Pool; Removing The Pool Cleaner From The Pool - Maytronics Basic 4-UNI Instrucciones De Uso

5.2. Putting the Pool Cleaner into the pool

If your Pool Cleaner is equipped with brushes that
contain sponges, dip the brushes in the water and
squeeze them so that they will absorb water the first time
you use the Pool Cleaner, or if the brushes have dried out
between uses.
Holding the Pool Cleaner upside down in the water,
gently rock it back and forth with your fingers holding
the plastic doors on the bottom lid open to release
trapped air. Continue until no more bubbles are released.
Release the Pool Cleaner and let it sink to the floor
of the pool.
Make sure that the floating cable is free of any
obstructions.
To avoid kinks in the floating cable, place approximately
enough cable in the water for the Pool Cleaner to reach
the farthest corner of the pool.
Turn the power supply ON.
The Pool Cleaner will now operate until it has
reached the end of the cleaning cycle.

5.3. Removing the Pool Cleaner from the pool

Turn OFF and unplug the power supply.
CAUTION
Robotic Pool Cleaner Basic 4-UNI User Instructions
|
ON
OFF
5