Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the Power Cut
-
Place the guide trolley with the control shaft onto the floor.
-
Place one foot firmly on the control shaft.
-
Hold the Power Cut firmly as shown in the illustration. Hook
it in the clamps (10) on both sides and pull firmly back as far
as it will go, while swinging the handguard (11) towards the
support plate (12).
Note: There might be an extra leg on the Power Cut (on 16" units)
or a leg with rollers. If so, remove it prior to assembly.
-
Press the handguard (11) onto the mounting plate between
the two retainers (13).
-
Depress the safety lock button on the Power Cut (see Power
Cut operating manual).
-
Fold the locking clamp (14) over (A) and secure it (B) with
the eccentric piece (15).
-
Block the eccentric piece with the quick action lever (16).
Note: The quick action lever (16) can be brought into the desired
position by pulling it the direction of the arrow and then turning.
Pulling the quick action lever releases the screw. It can be tight-
ened again by "returning" the lever.
Adjusting the gas lever action
The gas lever and Bowden cable is preset at the factory. If the
gap between the Power Cut gas lever (18) and the gas actuator
(17) is less than about 9 mm, proceed as follows:
-
Loosen the two nuts (19) and turn the Bowden cable (20) in
the appropriate direction.
-
Following adjustment, retighten the nuts (19).
Important:
Make sure that there is this amount of gap between the gas
actuator and the gas lever on the Power Cut. Otherwise, the
cutting disc can turn in an uncontrolled manner when the Power
Cut is turned on.
Check this gap before each starting!
A
14
15
B
18
11
10
12
13
11
16
17
9 mm
19
17
19
20
7
Publicidad
