Ryobi SwiftClean PCL756 Manual Del Operador página 5

WARNING:
Do not clean over electrical outlets located on the floor.
Water may drip from the unit after use and can puddle. To
avoid damage, do not place the unit on wood or laminate
surfaces. If setting unit aside for more than a few minutes,
place onto a towel or other absorbent material to catch
any drips. Failure to follow these rules may cause serious
injury or damage to property.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
CAUTION:
Avoid picking up hard, sharp objects with this product,
as they may cause damage.
CAUTION:
Do not use this appliance to clean or groom animals.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of wet or dry surfaces
 Light-duty cleaning of upholstery
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
WARNING:
Make sure the latch on the bottom of the battery pack
snaps in place and the battery pack is fully seated and
secure in the battery port before beginning operation.
Failure to securely seat the battery pack could cause the
battery pack to fall out, resulting in serious personal injury.
NOTE: To avoid serious personal injury, always remove the
battery pack and keep hands clear of the lock-out button
when carrying or transporting the tool.
 Depress the latches on each side of the battery pack.
 Remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
OPERATION
REMOVING AND FILLING THE SOLUTION
TANK
See Figures 2 - 3, page 8.
Use the included Oxy Cleaning Solution undiluted to fill the
solution tank.
NOTICE
Use only RYOBI brand Oxy solution. Do not use other
chemicals as this may damage the internal parts of the
unit and void your warranty.
 Remove the solution tank by lifting the tabs on the tank
straight up.
 Remove the cap on the tank by rotating counterclockwise.
 Fill the tank with cleaning solution.
NOTE: Wipe off any excess solution that may have spilled
onto the outside of the Oxy Cleaning Solution.
 Replace the cap on the solution tank by rotating clockwise.
Avoid cross-threading the cap and be sure it is tightened
securely.
 Align the cap and the tab on the solution tank and press
down firmly. You will hear a slight 'click' when the cap
has correctly locked into the unit.
NOTE: Be sure the tank is installed properly to avoid any
leakage.
STARTING/STOPPING THE SPOT CLEANER
See Figure 4, page 8.
Starting and stopping the vacuum:
 Depress the ON/OFF switch to turn on the vacuum.
 Depress the ON/OFF switch to turn off the vacuum. When
the ON/OFF switch is pressed to turn off the vacuum, the
roller brush will also be decativated.
To apply the cleaning solution:
 Press and hold the spray button to apply cleaning solution.
 Release the spray button to stop the cleaning solution
application.
NOTE: The cleaning solution is applied only while the spray
button is being pressed.
Activating the roller brush:
 Press the roller brush button to activate roller brush.
 Press the roller brush button again to deactivate the roller
brush.
NOTE The vacuum will still be activated when the roller
brush is turned off. To turn off both the vacuum and roller
brush, press the ON/OFF switch.
5 — English