Cameo PHANTOM F5 Manual De Usuario página 7

Idiomas disponibles

VENTILATION SLOTS

Ventilation slots are located on the top of the device. Ensure that the ventilation slots are not covered and that air can circulate freely.

SECURING POINT

Securing point for attaching the device on crossbeam installations.

OPERATION

NOTES

• Remove the protective film from the front of the fog machine before using it for the first time.

• After connection to the power supply the fog machine's heating phase will start (approx. 4 minutes). During this time the display will show

"UP" and the fog output cannot be started. After the heating phase is completed the previously set DMX start address will be shown on the

display when a DMX controller is connected to the device. In cable remote operation the green LED on the remote will light up. Operation by

DMX controller has priority over operation by cable remote.

• The fluid canister has a canister illumination to make fill level monitoring easier. In the heating phase red LEDs are permanently on. Once

the heating phase has been completed and the device is ready for use, blue LEDs light up. Check the fill level regularly and refill with fog

fluid as required (disconnect device from power supply before refilling).

• Do not operate the fog machine without fog fluid!

In order to remove fluid residue in the vaporizer system of your fog machine and thus ensure a long service life, clean the vaporizer system

regularly (approx. every 60 operating hours). To do so, use the special Cameo cleaning fluid for fog machines and follow the instruction on

the bottle label.

CONFIGURING DMX MODE

Press MODE to access the processing menu and press UP or DOWN until the display shows the menu item "Addr". Confirm with ENTER

then select the desired DMX start address by using the UP or DOWN buttons (hold down for fast value change) and confirm the selection

by pressing ENTER.

SETTING DMX MODE

Press MODE to access the processing menu and press UP or DOWN until the display shows the menu item "chnd" (Channel Mode).

Confirm with ENTER and then select the desired DMX operating mode by using the UP or DOWN buttons (1ch / 3ch). Confirm your

selection with ENTER.

Clphantomf5