Peavey PV 15 PM Manual Del Operador página 17

Idiomas disponibles

T O p p a n e l

GROUND LIFT

Switches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.

PRIMARY INPUT

The primary input is switchable between line-level and mic-level input. The line-level input is of the medium impedance

balanced type, and when switched to mic-level(6) it is of a typical low-Z mic input impedance. Jack (5) is a combo female

XLR and 1/4" TRS connector.

PAD

Switches the sensitivity of the primary input (5) from line-level to mic-level sensitivity. Pushed in, the sensitivity is set for

line-level input signals. When the switch is not pushed in, the sensitivity is increased by 30 dB so it is suitable for mic-level

signals.

PAD STATUS LED

Illuminates green when PAD switch (6) is in line-level mode, and yellow when the PAD is in mic-level mode.

VOLUME

Controls the gain (level) of the Primary Input (5) of the powered speaker system. It is used to directly set the system output

level for the input signal.

POWER/CLIP LED

Illuminates GREEN when the electronics receive power (when the Power switch (2) is On). Illuminates RED when amplifier

clipping is occurring or the unit has tripped the thermal protection system.

LINK OUT

Link Out is a 1/4" post-level send intended for the use of linking multiple PV

would connect to the 1/4" connections of the MIC/LINE (5) input of the next PV

15 PM's in the line should have their respective PADs (6) engaged and Level control (7) set to mid-position. The first PV

can use it's level control to set the volume for all of the other PV speakers in the line.

DIRECT IN

Direct In is a 1/4" line input that can be used to drive the PV

input jack has switching contacts that disconnects the PV

not affect the volume of the speaker.

15 PM's in a line. In that case, the Link Out

15 PM in the line of PV speakers. All of the

15 PM directly from a mixer, or other line level source. This

15 PM pre-amp, therefore the level control on the PV

15 PM does