Publicidad
Idiomas disponibles
Idiomas disponibles
The alarm will only be deactivated as soon as the measuring chamber is
free of smoke.
•
This device generates two different alarm signals. So you can distinguish,
WHERE and by WHICH device the alarm is triggered. You will clearly
distinguish between the trigger alarm (primary alarm) and all other alarm
sounds (secondary alarm).
•
The alarm can be deactivated:
•
by pressing the test button (front) of a secondary detector. Only this
device will be deactivated.
•
or by pressing the test button of the primary detector. After a delay of
approx. 20 seconds, all alarm sounds will be deactivated.
•
If the smoke detector should have a malfunction, this will be indicated by
2 or 3 short tones.
•
Malfunctions can be caused by dust, external electromagnetic disturbances
or extremely bright light sources. Please clean the detector as described
in the point Maintenance.
•
If the malfunction cannot be eliminated through maintenance or position
change, please contact your specialist dealer.
TAKING CARE OF YOUR SMOKE DETECTOR
To keep your detector in good working order, you must test the detector
weekly, as referring to section "TESTING YOUR SMOKE DETECTOR".
•
Replace the detector battery once a year or immediately when the low
battery "beep" signal sounds once a minute. The low battery "beep"
should last at least 30 days.
•
If the alarm horn begins to beep once a minute, this signal means that the
detector's battery is weak. Replace new battery immediately. Keep fresh
batteries on hand for this purpose.
•
Nevertheless, the detector will remain operational during this time.
After battery change, the detector will automatically carry out a new calibration
and a self test (every 24 hours), i.e. the detector even notices slight pollution,
but it remains identical in its smoke sensitivity. After this procedure, a long
beep tone will sound.
•
Open the cover and vacuum the dust off the detector's sensing chamber
at least once a year. This can be done when you open the detector to
change the battery. Remove battery before cleaning. To clean detector,
use soft brush attachment to your vacuum. Carefully remove any dust
on detector components, especially on the openings of the sensing
chamber. Replace battery after cleaning. Test detector to make sure
13
Publicidad
