Zibro R 417 TC Instrucciones De Uso página 56

If the heater has been used only a few times and the wick adjustment knob is not
locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the
wick in the highest position for ignition (Section C).
After having ignited the heater, always check whether the combustion
chamber ¿ is level, by sliding it slightly to the left and the right by its handle
(Fig. E) ´. This should be a smooth movement. If the combustion chamber is
L
not level, this will cause smoke and soot to develop.
D
THE BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can
check whether the heater is burning well. Too high a flame may cause smoke and
soot, whereas too low a flame causes smells. The page opposite the folding page
shows the minimum and maximum permissible burning heights of the flame (Fig. Q).
The flame can be slightly adjusted with the knurled wick adjustment knob · (Fig. L).
If the flame remains low after the adjustment, the wick height must be
adjusted (refer to Section F).
Too low a flame may also be caused by:
insufficient fuel
poor fuel quality
insufficient ventilation
wastage of the wick
This heater is fitted with a safety system that ensures that it switches off if you
lift the exchange tank out of the heater. To switch the heater on again, put the
exchange tank back and follow the steps in chapter C.
E
SWITCHING OFF THE HEATER
Let the heater burn at its lowest setting for approximately one minute. Push the
OFF-button ³. The flame will extinguish after a little while (Fig. M).
In cases of emergency: switch off the heater with the OFF - button ³ (Fig. M).
F
M
ADJUSTING THE WICK HEIGHT
After a period of time the combustion may no longer be high enough (Section D). In
that case you can adjust the wick height to improve the flame. To do this, the heater
must have been switched off. Follow the procedure below:
Push the OFF - button ³ (Fig. M).
1
(fill the tank)
(contact your dealer)
(leave window or door ajar)
(contact your dealer or replace the wick,
refer to section M)
4
55