Hilti SIW 2-A12 Manual De Instrucciones Original página 12

▶ If the battery is too hot to touch, it may be defective. Put the battery
in a place where it is clearly visible and where there is no risk of fire,
at an adequate distance from flammable materials. Allow the battery
to cool down. If it is still too hot to touch after an hour, the battery is
faulty. Consult Hilti Service or read the document entitled "Instructions
on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage
and use of lithium-ion batteries. → page 13
Read the instructions on safety and use of Hilti Li-ion batteries
that you can access by scanning the QR code at the end of these
operating instructions.
3 Description
3.1 Product overview
Forward / reverse switch
@
Grip
;
Light
=
Installation opening for acces-
%
sories
3.2 Intended use
The product described is a hand-held cordless impact wrench. It is designed
for tightening and releasing nuts, bolts, anchors and wood screws.
Use the cordless wrench only for applications that do not require a pre-
cise/specified torque.
• For this product, use only Hilti lithium­ion batteries of the B 12 series.
• Use only Hilti battery chargers of the C4/12 series for charging these
batteries.
3.3 Items supplied
Impact wrench, operating instructions
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
3.4 Charge status display
The charge status of the Li­ion battery is displayed after pressing one of the
release buttons lightly (press only until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
8 English
1
&
(
)
+
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Battery state of charge indica-
tor
Battery release button
Control switch
Tool holder (3⁄8" square drive)
2384753
*2384753*