Moen ET900 Guia De Instalacion página 16

MATCHING YOUR REMOTE
CONTROL CODE
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate
radio frequency energy and if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, if there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on the user is encouraged
to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
conntected to.
Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not
expressly approved by Moen
Incorporated could void the user's
authority to operate the equipment.
1
2
3
Unplug the toilet.
Press the "Stop" key for a few seconds until
the dryer temp / water temp / seat temp
lights start to blink. The Level light flickers.
Place the remote control near the toilet and
plug the product back in. The lights of dryer
temp / water temp / seat temp will stop
blinking and stay solid to indicate
successful pairing.