Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATION, Pic. B
1
Rotisserie ......................................................... 1 pc.
2
Bottom fixation for skewers ............................. 1 pc.
Drip tray ........................................................... 1 pc.
3
4
Spit clamp ........................................................ 2 psc.
Spit ................................................................... 1 pc.
5
Skewer ............................................................. 7 pcs
6
Top fixation for skewers ................................... 1 pc.
7
User's manual ................................................. 1 pc.
Warranty card .................................................. 1 pc.
DEVICE PARTS, Pic. C
1
Glass door
2
Rubber feet
3
Control panel
Operation indicator
4
Heating unit (tubular heating element)
5
Lid
6
Detachable handle
7
Upper part of roasting jack
8
USING
Control panel, Pic. C-3
- Power selection button: 0 position – switched off;
I position – one-half power; II –full power.
- Timer; range from 0 to 60 minutes.
Setting-up procedures
Clean the device body with a dry and soft cloth prior the
first use. Wash skewers
2
7
skewers
, spit and clamps
and dishwashing liquid. Carefully dry all components.
Ensure that the device is unplugged prior assembling or
dissembling procedures.
Start a dry run at the full power for 15-20 minutes turning
the timer handle for 15-20 minutes in order to remove
industrial smells. Ventilate the room and allow the device
to cool down.
Before to switch on/off the device, ensure that
the timer handle
selection button
Operation Procedure, Pic. D
1. Plug in the device at a socket. Open the door and
install the drip tray, Pic. D-1. The lighting is automatically
switched on when the door is opened.
It is prohibited to operate the device without
the drip tray.
2. Close the door, push the button
position; Set the timer
the device.
The device is equipped with a protection
system. It is impossible to switch on the device
if the door is not closed in a proper manner.
3. Take in hands the spit with meat/poultry already fixed
on it or skewers with BBQ and first of all install the lower
end of the spit to the lower seat and then install the upper
end of the Spit to the upper seat, Pic. D-4.
14
6
3
, drip tray
, fixations for
5
4
with warm water
is in
position, and power
0
is in the
position
, choosing the
for 10-12 minutes to preheat
4. Close the door, turn the timer handle
clockwise direction in order to select the time of cooking.
The process of cooking starts automatically.
5. Upon expiration of preset time, there will be an
acoustic signal and the device is automatically switched
off. Push the button
NOTE:
• In order to switch off the device while cooking – turn
the timer handle
• If required, if the dish is not cooked well or the crust
is not fried enough – you may add an extra time by
turning the timer handle
6. Open the door and take out the Spit with meat with
heat-resistant gloves or special tweezers. In order to do
so - lift slightly the spit and then pull on the upper part.
Remove the skewers one after one using heat-resistant
gloves or oven cloth only. In order to remove all skewers
– use the timer handle to rotate the roasting jack.
7. Put the spit with meat/poultry/fish to the cutting board,
wait for a while to cool the dish down, loosen the fixations
at the Spit clamps and remove them. Remove the poultry/
meat from the roasting jack. You may also use special
heat-resistant gloves.
8. Disconnect the device from the power source.
Using of spit
1. Take the spit and install a clamp on it, Pic. D-2-1.
2. Spit the preliminary prepared poultry (meat) to the
spit such that it is located closer to the top part of the
roasting jack, Pic. C-8.
3. Tightly fasten the clamps from the both sides. The
clamps are installed rotationally in the plane of ∟90°
one another, Pic. D-3. All parts of poultry/meat shall
be fixed without hanging. We recommend tying up the
poultry in order to prevent separation of wings/legs while
cooking. You may fix the legs with the clamp and the
wings with toothpicks.
NOTE:
Poultry, meat, fish shall be completely defrosted
and marinated, if required. According to your taste
preferences, to achieve the best taste, we recommend
to add some vegetable oil.
The max weight of poultry is 2 kg.
.
Using of skewers
1. Install upper and bottom fixations for skewers to the
roasting jack, Pic. D-5.
2. Split the preliminary prepared BBQ (kebab,
sausages, small sausages, knackwursts or vegetables),
Pic. D-6. Install the skewers to the roasting jack.
NOTE:
• In order to achieve the best degree of BBQ doneness,
we recommend splitting the meat in not tight manner
or mixing the meat slices with vegetables. In addition,
we recommend placing fatter and larger slices on the
top.
• We recommend to place skewers with meat a little
closer to the top edge, and leave about 1,5-2 cm free
at the bottom.
• Use wooden sticks if you want to rotate skewer with
meat around its axis.
0
, choosing the
position.
to the
position.
for extra 10-15 minutes.
in the
Publicidad
