INVENTOR MP862W Manual De Usuario página 14

4.
Remove the three plastic caps
from the side you are going to install
the door, and place them on the
side where the door was originally
installed, in order to cover the three
screw holes.
6.
Check if door is aligned
horizontally and vertically and that
the door when shut is completely
sealed from all sides.
14
5.
Place the door on the desired side
making sure it is in its upright position.
Screw the top two screws of the door
hinge. Slightly tilt, for better positioning,
and screw the bottom hinge
7.
Finally tighten the bottom hinge and re-adjust
the foot on the opposite side for correct leveling.
into place, and also screw the
removed foot on the other side.
Once completed clip on the top
plastic cap.
EN