Hansgrohe PuraVida 15771 Serie Instrucciones De Montaje página 2

English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Flow rate @ 44 PSI
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This trim is for use with iBox Universal Plus model
01850181 (not included).
• This thermostatic mixing valve is for use with a
showerhead rated at 1.1 GPM (4.2 L/min) or
higher.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
6.9 GPM (26.1 L/min)
• Inspect the check valves and filters at least once
per year. Replace if dirty or worn.
• Should the volume of water decrease over time,
inspect and clean the filters on the thermostatic
cartridge. After reassembly, set the high
temperature limit stop and justify the handle.
• To prolong the life of the themostatic cartridge,
regularly run it through its full range of
temperatures.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.