Imetec E7803 Instrucciones Para El Uso página 17

A little smoke comes out
of the appliance when it
is switched on for the first
time.
Impurities come out of the
plate of the new iron.
Drops of water come out of
the plate.
The device does not
produce steam
The plate is dirty.
Patches remain wet while
ironing.
The iron cannot be placed
in an upright position.
Pursuant to Art. 26 of Italian Legislative Decree no. 49 of 14 March 2014 "Implementation
of Directive 2012/19/EU on waste electrical and electronic equipment (WEEE)", the
crossed bin symbol on the appliance or its packaging indicates that the product must
be disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for
electrical and electronic equipment.
Alternatively, instead of handling the disposal, the appliance can be handed over to
the retailer when a new, equivalent appliance is purchased.
Retailers of electronic products having a sales area of at least 400 m2 can also be
handed electronic products that are to be disposed of measuring less than 25 cm,
free of charge and with no obligation to buy.
Appropriate separate collection for the subsequent procedure for the decommissioned
appliance for recycling, which includes treatment and environmentally friendly
This is absolutely normal and is
due to the expansion of the plastic
material.
This can occur in a new iron.
The iron temperature adjustment
knob (10) is set to a temperature that
is too low for steam ironing.
The appliance is not
on.
Yo are not pressing the
steam button (11).
The water in the reservoir has
finished.
You are using dirty water or perfumed
substances.
The impurities or chemical
substances found in the water have
deposited on the plate.
You are ironing at a temperature that
is too high.
Sometimes patches remain wet after
being steam ironed as the steam
condenses on the ironing board.
The iron has been designed to be set
horizontally.
DISPOSAL
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used a
few times.
Adjust the temperature for steam ironing
(see the "IRONING" chapter and FIG. B).
Press the ON/OFF button (1).
Keep the steam button (11) pressed as you
iron.
Fill the reservoir (see chapter: FILLING THE
RESERVOIR WHILE IRONING).
Empty the tank and refill it with clean water.
Wait for the plate to cool down
and clean it with a damp cloth.
Wait for the plate to cool down
and clean it with a damp cloth.
Pass the iron a number of times on the wet
patches without dispensing steam. If the
lower part of the ironing board is wet, dry it
with a dry cloth.
Use a mesh ironing board to prevent the
steam from condensing on the ironing board.
Place the iron on the heat resistant
resting mat.
EN
15