Kicker ZXDSP1 Manual Del Propietário página 9

High/Mid, Mid-Bass and Low wiring
In this confi guration, the Front Row is used to drive your mid-range and tweeters, mid-bass drivers, and
subwoofers separately; each with their own amplifi er, crossover points and time alignment. Use this confi guration
with a dedicated midbass driver and either a coaxial or set of components providing your mid and treble
frequencies.
Set the FRONT FREQUENCY switch to a factor of X1 and adjust the HI-PASS crossover for mid-range and high-
range use (Recommended starting point of 160Hz).
Confi gure the REAR/SURROUND channel for mid-bass by using the crossovers as a band-pass fi lter. Set
the LO-PASS switch to ON and the FREQUENCY switch to a factor of X1, then adjust both the HI-PASS and
LO-PASS crossovers accordingly
(Recommended starting points of 80Hz
and 160Hz, respectively).
Adjust the SUBWOOFER channel's
LO-PASS crossver to 80Hz.
This confi guration allows you to time
align your left mid/mid-bass speaker
and left tweeter separately for
an optimal driver's-side listening
experience. You will not be able to
use the Surround Sound function
and it should be turned OFF.
Once the crossovers and
OUTPUT LEVEL controls on your
Front Row are confi gured, use
the remote control to fi ne-tune
the sound.
sub channel
subwoofer amplifi er
2012 FrontRow (ZXDSP) Rev G.indd 9 2012 FrontRow (ZXDSP) Rev G.indd 9
sub full
mid-bass
channel
2 or 4-channel
full-range amplifi er
factory source unit /
factory amplifi er
full-range signal
Front Row
high/mid-channel
(coaxial speakers)
2 or 4-channel
full-range amplifi er
4/30/2012 1:55:52 PM 4/30/2012 1:55:52 PM
9