Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
Power/Protect-LEDs
(2)
Remote jack for the included bass remote control
(3)
Selector* LP/BP (Lowpass/Bandpass) – FULL – HP (Highpass)
(4)
Gain level controller
(5)
Bass boost controller
(6)
Phase controller
(7)
Lowpass filter controller
(8)
Subsonic controller
(9)
RCA audio signal outputs to run additional amplifiers
(10) RCA audio signal inputs from the headunit
*
Set the X-OVER switch only to "FULL" or "HP mode", if you have a seperate signal processor
or head unit with an internal crossover, which already sends a low-pass filtered audio signal
to the amplifier. If you want to cutoff the lower frequencies audio signal, you can select the "HP"
mode and adjust the cutoff frequency with the subsonic filter controller.
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Vehicle's battery
(5)
In-Line Fuse (not included in the scope of delivery)
(6)
Turn on wire from the headunit or the electrical antenna
(7)
Amplifier fuses
1-CHANNEL MONO OPERATION (FIG. 3) WITH 1 SUBWOOFER
(1)
RCA audio signal input from the headunit, line output left or SUB OUT
(2)
RCA audio signal input from the headunit, line output right or SUB OUT
(3)
Remote control to adjust the bass level e.g. from the driver's seat
(4)
Subwoofer (2 - 8 Ohms)
1-CHANNEL MONO OPERATION (FIG. 4) WITH 2 SUBWOOFERS
(1)
Remote control to adjust the bass level e.g. from the driver's seat
(2)
RCA audio signal input from the headunit, line output left or SUB OUT
(3)
RCA audio signal input from the headunit, line output right or SUB OUT
(4)
Subwoofer 1 (4 - 8 Ohms)
(5)
Subwoofer 2 (4 - 8 Ohms)
ENG
11
Publicidad
