Orbegozo SP 6000 Manual De Instrucciones página 19

SP 6000
F. Press , display will show before selected time of switch on. Press
off time. Such as set the shutdown time at 13:00:
G. Press " / " to set the target temperature (temperature range 10-49ºC).
H. By last press to confirm the configuration. Repeat step b-g to set more days.
i. To cancel the weekly program, press
The heater will work in previous mode.
- After weekly program is set, press
- Press " / " to check the desired temperature in each program.
- The switch on periods goes 0-24 hours, you can set the minutes.
- TIME OFF cannot be less than TIME ON.
- When TIME ON is the same as TIME OFF, heater will be into standby mode.
Set open window detection (only by remote control).
a. Press , heater will enter into working status. Heating for a moment until stable.
b. Press by remote control, it will light the logo
temperature. Press "
temperature drops 5-10ºC for 10 minutes, the heater will stop working and enter into standby mode for
30 minutes. If you want to turn it on again press
To disconnect open window detection mode press
Example of display with follow situation: room temperature lower than 23ºC, selected temperature 23ºC,
open window detection mode turn on.
, "P" light in display will light off. The weekly program will be off.
/ /
/ " to set target temperature. During open window detection mode, if room
/ to check the program of each day and each period..
in display. Display will show "23" as default
.
again and symbol
continuously to set the switch
will turn off in display.
19