Ryobi RYAC801 Manual Del Operador página 13

INSTALLING INTERMEDIATE HANDLE
See Figure 4.
 Align the holes on the intermediate handle with the holes
in the lower handle as shown.
 Insert bolt through both handles with the threaded end
facing out.
 Install the handle knob and tighten securely to secure the
bolt in place.
 Repeat on the opposite side to secure the intermediate
handle in place.
INSTALLING LOUVER ROTATION LEVER
See Figure 5.
 Insert the threaded end of the louver rotation lever mount-
ing bracket through the hole in the intermediate handle.
The threaded end should face forward.
 Install the washer and cap nut; tighten securely.
 Route the upper end of the lever between the intermedi-
ate and lower handles and install over the lower end of
the lever. Align the holes in the two parts of the lever and
insert the hitch pin through the holes as shown to secure.
 Rotate the lever in both directions to verify the proper
functioning of the lever and the louvers.
ASSEMBLY
INSTALLING UPPER HANDLE
See Figure 6.
 Align the holes on the upper handle with the holes in the
intermediate handle as shown.
NOTICE:
Do not allow the starter cable to become pinched or
trapped when aligning the handles.
 Insert bolt through both handles with the threaded end
facing out.
 Install the handle knob and tighten securely to secure the
bolt in place.
 Repeat on the opposite side to secure the upper handle
in place.
 Install the cable clips if not already installed, then route the
starter cable through the openings in the clips to secure.
9 — English