Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
The display scrolls
"CONNECT BATTERY".
Charging a 12V battery,
but the display shows
"CHARGING 6V".
Red
LED is solid and the
display scrolls "CHARGE
ABORTED-BAD BATTERY".
18. BEFORE RETURNING FOR REPAIRS
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number
from Customer Service at Schumacher Electric Corporation.
19. SPECIFICATIONS
Input Voltage ................................................................................120V AC @ 60Hz, 0.91A
Output Voltage .......................................................6V or 12V, with Auto Voltage Detection
Output Current Rating ..........................................................................2A @ 6V; 3A @12V
20. REPLACEMENT PARTS
Battery clamps (quick-connect)..................................................................... 3899002636Z
Ring connectors (quick-connect) ................................................................. 2299002042Z
12V accessory plug (quick-connect) ............................................................. 3899001401Z
POSSIBLE CAUSE
The clamps are not making a
good connection.
The fuse is bad.
Battery may be extremely
discharged.
The battery is bad.
The battery is too large for
the charger.
If these solutions do not eliminate the problem,
or for more information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
• 13 •
SOLUTION
Check for poor connection at
battery and frame.
Replace the in-line fuse for
the ring connector or 12V
accessory plug connector.
No problem; the charger
will eventually recognize
battery as 12V and charge
completely.
Disconnect charger from the
AC outlet and then remove
the clamps. Do not continue
to try to charge the battery.
Have the battery checked or
replaced.
You need a charger with a
higher amp rate.
Publicidad
