Retekess TD174 Manual Del Usuario página 5

Operation instruction
1.Connect the keypad transmitter to power source, it executes the self-testing
procedure and then power indicator turns on
2.Take out the pager and plug it into the charging slot, the pager will be powered
on automatically, the LED1 indicator lights up and flashes once every 3s. The
blue LED lights on when the pager enters charging mode.
3.When client places an order, the waiter gives one pager to him(her) and note
down the number on the pager
4.While the order is ready, the waiter enters the number through keypad to call
the client (number), the pager receives signal and prompts vibration/buzzer/light
for 5min, after that only the 3 LED indicators flicker.
Client can press the "Power/Reset" button to sop the notice or put it back to
charging slot to stop it.
5.The client gives the pager back, then the waiter can put the pager into to
charging slot and provide service for other clients.
6.While the pager is in charging, press the number on keypad, the corresponding
pager LED indicators will flicker 3 times to report its position
Note:
1)In daily working, the pager can be powered on all the time. If not use them for
a long, remember to power them off.
2)If the pager system has not been used for a long time, you need to charge it for
a while before giving the pagers to the clients.
3)The pager must be paired to the keypad before using. Please refer to the
pairing method below.
Pairing method
【 PARING 】 Short press the "SET" button, the LED1 indicator lights on, then
press the call number on the keypad，The pager gets the signal and LED1 lamp
turns off ，the pairing is successful. If the pager does not gets any signal in 10s,
it will quit pairing status automatically.
【DELETING】 Press and hold on the "SET" button for 5s, the LED1 indicator
will be ON-OFF,then release the button, the paired pager will be deleted
【MODE】 Switch mode: Vibration /Beep/Vibration + Beep
Note: You need to take off the transparent cover and number paper to find the
SET and MODE buttons.
Change number paper
Take out the transparent cover in the front of the pager, then put a number paper
inside the paper slot. And then put the transparent cover back.
3