Hansgrohe Axor Starck 10020 Serie Manual Del Usuario página 7

Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The pressures of the cold and hot water connections
must be balanced.
Technical Data
Operating pressure:
Recommended operating pressure:1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Test certificate
10020XXX/10022XXX
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
Bedienung
open
English
max. 10 bars
16 bars
max. 80° C
65° C
approx. 7 l/min
3 bars
WRAS
0209014
close
If the continuous water heater causes any pro-
blems or there is not enough flow of water, the
waterdimmer (5a) located behind the aerator must
®
be removed.
Spare parts (see page 3)
1 flange
2 handle for Starck
3 cartridge cpl.
4 handle for Starck Puro
5 aerator cpl.
6 pop up rod
7 connection hose
8 fixing set
9 extension hose 300 mm
10 lever arm cpl. 200 mm
lever arm cpl. 340 mm
Special accessories
X special tool set
(not part of delivery)
XXX = Colors
000 chrome plated
810 satinox
®
cold
96427X X X
10090XXX
96339000
10092XXX
94005XXX
94006XXX
96321000
13961000
13098000
96007000
96324000
58085000
hot
7