Blancone CARE True Light Manual De Instrucciones página 4

EN
BlancOne CARE True Light
®
Lamp for dental photography
with smartphone
CONTENTS
- TrueLight: Lamp with support for smartphone
- Type-C charging cable
- Hex key to adjust smartphone clamp (6,7)
- Aluminum tripod
- Adjustable support
- Wireless Bluetooth remote control
- Lamp case and accessories
- Instructions
Congratulations on purchasing your TrueLight lamp.
Before using it for the first time, you are advised to
carefully read and follow the instructions shown below.
WARNINGS
TrueLight is a high-tech device that must be used with
caution. Any problems due to incorrect use are not
covered by the warranty.
Practitioners must warn patients not to look directly at
the light source (LED lighting), and to wear protective
glasses if necessary.
PRODUCT DESCRIPTION
3
2
1
10 8
9
9
FIRST TIME USE
Use the cable supplied in the package to charge the
TrueLight battery. Insert the Type-C cable into the
socket beneath the TrueLight(4)and plug the USB end
into the charger, connecting it to the power supply.
The red light (2) above the device will turn on while
it is charging, the yellow light will indicate that there
is insufficient power, and the green light will come on
when it is fully charged.
TRUE LIGHT takes approximately 5 hours to fully re-
charge. Once fully charged, the battery has approxi-
mately 18 hours of autonomy.
Instruction Manual
4
CLAMP FOR SMARTPHONE
The smartphone clamp (6) on the back of the True-
Light is adjustable. The smartphone clamp can hold
devices with a width of 55-85mm, making it suitable
for most smartphones on the market.
The hex screw (7) on the mobile carriage of the clamp
can be loosened in order to slide the carriage and ad-
just the position and height of the smartphone, so that
the lens remains in the center of the TrueLight window
(8).
A) Positioning
1
Without using excessive force, follow these instruc-
tions to position the clamp:
6
8 7
5
4
B) Removing
the smartphone the smartphone
1. Insert the smartphone into the clamp as shown
below (A). Press the smartphone on the upper
support to open the clamp and insert the device.
2. Slide the smartphone into the clamp to correct
the position of the lens.
3. After positioning the smartphone, you may need
to move the clamp to position the target in the
center of the window.
a. Gently push the smartphone through the
spring of the slot to remove it (B)
b. Use the millimeter scale on the back of the
TrueLight to facilitate adjustment.
c. Loosen the hex screw (do not remove it
completely) and gently slide the carriage of
the clamp in the required direction.
d. Tighten the hex screw.
4. Make sure that the lens of your phone is centered
in the TrueLight window. If not, repeat step 3.
Correct insertion
of camera
BlancOne CARE | TRUE LIGHT
®
C) Correctly
inserted
Incorrect insertion
of camera