Publicidad
Idiomas disponibles
Idiomas disponibles
Tool features
1
Enclosure
2
Hanger
3
Stroke adjustment
4
Glue stick guide
5
ON/OFF button
6
SET button (GlueMatic 7011 only)
7
UP button for increasing temperature
(GlueMatic 7011 only)
Important advice
L Do not use liquid or pasty adhesives.
L Nozzle and molten glue can reach temperatures of
over 200 degrees Celsius. Beware of burns!
L You could burn yourself! After skin contact with
hot glue: immediately cool with cold water. Do not
try to remove hot-melt glue from the skin. If neces-
sary, seek medical attention.
L After eye contact with hot-melt glue: immediately
cool for approx. 15 minutes with running water
and consult a doctor straight away.
L The area you are gluing must be free of grease,
dry and absolutely clean.
L Trouble-free operation can only be guaranteed
when using genuine STEINEL glue sticks.
L Do not use in conjunction with highly flammable/
combustible materials.
L Glue marks on clothing cannot be removed.
L Make sure heat-sensitive materials are suitable for
gluing with hot-melt adhesive.
L Drips of glue are best removed when cold.
Proper use
Hot-melt glue applicator for use with genuine
STEINEL glue sticks. The tool must only be used
indoors in a dry and well-ventilated environment.
8
DOWN button for reducing temperature
(GlueMaitic 7011 only)
9
LCD information display
(GlueMatic 7011 only)
10
Power cord
11
Stand (removable)
12
Feed trigger
13
Exchangeable gluing nozzle
14
Nozzle cap
L Do not pull glue sticks out of the applicator.
Hot glue running into the applicator may cause
damage.
L Optimum adhesion is achieved when the bond is
established instantly on applying the glue.
L Unplug when not in use or during prolonged work
breaks (more than 30 min.).
L Before inserting a new glue stick, wait a moment for
the cold cartridge to heat up. Never force the glue
stick through the applicator.
L After changing nozzle, screw on hand-tight
(4.2 Nm) using a tool, or the newly fitted nozzle
may not provide a tight seal, causing it to leak.
L Once heated up, the applicator must be stood on
the stand.
It must not be laid on its side.
L Unplug after use. Let the tool cool down com-
pletely before putting it away.
L On leaving the factory, the tool is automatically set
to stay switched OFF when the power supply is
restored after a power cut.
- 11 -
GB
Publicidad
