Orbegozo PWS 0547 Manual De Instrucciones página 16

PWS 0547
TABLE FAN
Connect the support bars and screw firmly.
If the plastic protectors are not assembled, install them with the screws
in the support bars' holes.
Put the engine between the support bars.
Before putting the screw into the holes, note that you should install
two round metallic pieces (pictures below) to avoid the fan's head
falling down.
The straight part of the metallic piece should face the front part of the
fan.
The round metallic pieces have some protrusions
to avoid the fan falling down.
Connect the rear grille to the motor's case and fix it with the four
screws.
Assemble the blades in the engine's shaft. The fastening screw should
coincide with the shaft's slot.
Connect the front grille and screw the grille's fastening screw.
Use the piece showed in the picture to insert the speed controller.
16