Automatic Frequency Matching (Remoset Function) - Monacor International JTS IN-164R /5 Manual De Instrucciones

Activating the lock
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group
setting mode is activated
2) Press the button SET repeatedly until the dis-
play shows
flashing
3) To activate the lock, press the button
display shows
4) Press the button SET to confirm The display
briefly shows
the normal mode
The indication LOCK (e) on the display
shows that the lock has been activated When
you press a button or when you set the on /off
switch (8) to OFF,
Deactivating the lock
1) Make sure that the on /off switch (8) is set to ON
2) Keep the button SET (6) pressed until the indi-
cation LOCK (e) starts flashing on the display
3) To deactivate the lock, press the button
The display shows
4) Press the button SET to confirm The display
briefly shows
normal mode
5.2 Automatic frequency matching
(REMOSET function)
Via a 2 4 GHz radio signal of the receiver, the trans-
mitter is matched to the transmission frequency of
the receiver The range of REMOSET transmission
may reach up to 10 m Transmission is not possible
when the receiver is locked (deactivating the lock
☞
chapter 5 1 4)
After setting the desired transmission fre-
quency on the receiver (
switching on the transmitter, press the button
REMOSET (3) When the REMOSET function has
been activated, the luminous ring of the button
starts flashing rapidly The display briefly shows
the identification number of the receiver (
ter 5 1 3) After matching the frequency, the trans-
mitter is set to the channel group and the channel
of the receiver The luminous ring of the button
lights permanently again
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
(lock off) and LOCK (e) starts
▲
(7) The
The receiver will return to
appears in addition
The unit will return to the
☞
chapter 5 1 1) and
☞
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
If the luminous ring keeps flashing after the REMO-
SET function has been activated, the receiver does
not receive a radio signal from the transmitter on
the transmission frequency adjusted, e g when
REMOSET transmission has failed (troubleshooting
☞ box below) or when the transmitter is muted
at the time of REMOSET transmission
If the transmitter has not been set to the channel group
and the channel of the receiver, check the following
adjustments on the transmitter:
 Has the lock function been activated on the trans-
mitter?
 Has the automatic frequency matching been disabled
on the transmitter?
 Does the identification number set on the transmitter
differ from the one set on the receiver?
Correct the corresponding setting on the transmitter
and press the button REMOSET once again
6 Specifications
Carrier frequency range: 506 – 542 MHz
▼
(5)
REMOSET transmission: 2 4 GHz
Audio frequency range: 40 – 18 000 Hz
THD:
Dynamic range:
Squelch:
Audio outputs, bal :
Ambient temperature:
Power supply:
Dimensions W × H × D
(w /o antennas):
Weight:
chap-
Subject to technical modification
☞ table on page 24
< 0 6 %
> 105 dB
pilot tone / noise mute
100 mV,
XLR (with 20 dB attenu-
ation switch) and
6 3 mm jack
0 – 40 °C
via power supply unit
provided and connected
to 230 V/ 50 Hz
210 × 42 × 195 mm
525 g
13