Brita Redi-Twist USS-335 Manual De Instrucciones página 15

<< Step continued from previous page
materials and tools needed
utility knife
Connect Tubing from RO System Head to Water Storage
Tank
• Use remaining 3/8" White Tubing
and determine length necessary to
connect Tank outlet (labeled "TANK")
on RO System Head to Water Storage
Tank.
• Cut 3/8" White Plastic Tubing square
with a sharp utility knife.
• Loosen the compression nut on the top
of the tank - DO NOT REMOVE.
• Wet end of tubing and insert into
compression nut of Tank Connector
fitting (which was connected to tank
previously).
• Tighten compression nut to secure
tubing to Tank Connector.
• Insert other end of 3/8" White Plastic
Tubing into outlet of RO System Head
(labeled "TANK") approximately 5/8"
until it stops.
USS-335 installation instructions
Step 6
CAUTION
3/8" white tubing to faucet
Kitchen 3/8" red tubing
Packaged Items
3/8" line to Drain
Faucet
to drain
Adapter Shown in White
Drain
Connector
COLD
HOT
1/4" line to Filter 1/4" white tubing t ter
1/4" red tubing to
membrane drain
connect to auxiliary faucet
Connect Water Lines
WARNING
1/4" line to Faucet
3/8" white tubing
1/4" line to Tank
to tank
Storage Tank
Loosen Compression Nut
Version 2.1I
15