Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING OPERATION
Install the device on a plane surface.
The liquid tank of the device needs to be filled with foam fluid before starting up operation and always
disconnected from the mains as fluid could be spilled.
Only use quality foam fluids available at your dealer. We recommend high-quality Eurolite Foam fluids (e. g.
EUROLITE Foam Fluid, 5 l). You must not use substances that are classified as "dangerous working
material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Caution! Ensure a minimum distance between foam machine and audience of min. 2m. Never direct the
foam output nozzle to the face or the eyes of people.
Installation
Install the device out of the public area. Please consider that liquid may be spilt during operation around the
device. The resulting slippery surface can cause accidents. Keep a minimum distance of 20 cm around and
above the device.
Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is constructed for a standing or hanging installation. If the device is to be installed overhead, the
following safety instructions are binding:
Please consider the
installation! The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of people.
DANGER TO LIFE!
EN 60335-1:1996 a
nd the respective national norms during the
16/32
00043721.DOC, Version 1.1
Publicidad
