KNOVA KN BD-46L Manual De Instrucciones página 7

ASSEMBLY
INSTALLING/REPLACING SANDING BELT
Idler roller
Positioning
bolt
Drive roller
Fig. 5
On the smooth side of the sanding belt, there is a directional
arrow. The sanding belt must run in the direction of the arrow.
• Using the hex key provided, loosen the positioning bolt
by turning the bolt counterclockwise.
• Move the sanding belt into a vertical position.
• Lock the sanding belt by retightening the positioning bolt.
• Pull the belt tension lever toward you to release the belt
tension.
• Place the sanding belt over the drive roller and idler roller
with the directional arrows running counterclockwise. Be
sure the sanding belt is centered on both drums.
• Push the belt tension lever back into place to apply the
belt tension.
NOTE: The belt tension lever is spring loaded; use extreme
caution when pushing the tension lever back into place to
avoid personal injury.
MOUNTING THE WORK TABLE FOR USE WITH
THE DISC SANDER
Fig. 6
C
Belt
tension
lever
Directional
arrow
Sanding
belt
Index pin
Work table
Washer
Table
lock knob
• Insert the work table index pin into the hole in the tool's
housing.
• Position a washer over the table lock knob then tighten
the table lock knob securely.
MOUNTING THE WORK TABLE FOR USE WITH
THE BELT SANDER
Index pin
Table
lock
knob
Washer
• Insert the work table index pin into the hole in the sanding
belt arm.
• Position a washer over the table lock knob then tighten
the table lock knob securely.
ASSEMBLING WORK SUPPORT
Socket
head
screws
Washers
• Place the work support over the holes in the side of the
sanding belt arm.
• Using a hex key, fasten in place with washers and socket
head screws.
6
Work
table
Fig. 7
Work support
Fig. 8