Publicidad
Idiomas disponibles
Idiomas disponibles
A - brush
3) Check that the wiper is properly installed. If not, install the wiper according to the
"Wiper Installation" instructions.
Press the switches on the control panel to ensure that the water spray engine, brush
engine, and suction engine are ready for operation. Check that the battery charge is
sufficient for cleaning. An acoustic signal will sound when the battery level is low. Turn
off the machine and charge the battery if necessary.
3.4.
Once the preparatory work is complete, the operator can proceed to clean the floor
Basic procedure for working with the device
1. Check that the sprinkler button and suction button are off. Then turn on the
machine with the ON/OFF switch on the control panel.
2. Lower the wiper lever so that the wiper completely touches the floor during
operation.
3. Press the sprinkler button on the control panel, and the solenoid valve will start
working, and the machine will start spraying water.
4. Press and hold the brush engine control buttons located on both sides of the handle
to start the brush rotation.
Working with the device
Publicidad
