Gardol GMSE 2045 Manual De Instrucciones Original página 31

9. Troubleshooting guide
Problem
Unit won't start or
starts but will not
run.
Unit starts, but engi-
ne has low power.
Engine hesitates.
No power under
load.
Runs erratically.
Smokes excessi-
vely.
Poor performance
when operated
Engine dies
Insuffi cient chain
lubrication
(the cutter rail and
chain get hot)
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GMSE_2045_SPK7_Teil1.indb 31 Anl_GMSE_2045_SPK7_Teil1.indb 31
GB
Probable cause
- Incorrect starting procedures.
- Too much fuel in the combustion
chamber following failed attempts
to start the saw.
- Incorrect carburetor mixture adjust-
ment setting.
- Fouled spark plug.
- Fuel fi lter plugged.
- Incorrect lever position on choke.
- Dirty air fi lter.
- Incorrect carburetor mixture adjust-
ment setting.
- Incorrect carburetor mixture adjust-
ment setting.
- Incorrectly gapped spark plug.
- Incorrect carburetor mixture adjust-
ment setting.
- Incorrect fuel mixture.
- Blunt chain
- Loose chain
- Empty petrol tank
- Fuel fi lter in the wrong position in
the tank
- Empty oil tank for the chain
- Oil lubrication openings moved
- 31 -
Corrective Action
- Follow instructions in the User Ma-
nual.
- Wait about 30 minutes until the fuel
in the combustion chamber has
evaporated before trying again to
start the chainsaw.
- Have carburetor adjusted by an Au-
thorized Service Center.
- Clean / gap or replace plug.
- Replace fuel fi lter.
- Move the lever to the correct positi-
on.
- Remove, clean and reinstall fi lter.
- Have carburetor adjusted by an Au-
thorized Service Center.
- Have carburetor adjusted by an Au-
thorized Service Center.
- Clean / gap or replace plug.
- Have carburetor adjusted by an Au-
thorized Service Center.
- Use properly mixed fuel (40:1 mix-
ture).
- Sharpen or replace the chain
- Tension the chain
- Fill up the petrol tank
- Completely fi ll the petrol tank or or
re-position the fuel fi lter in the petrol
tank
- Top up the oil tank for the chain
- Clean the oil entry hole/groove on
the guide rail.
24.02.2017 10:55:41 24.02.2017 10:55:41