Publicidad
Idiomas disponibles
Idiomas disponibles
4. Clean the light area
free cloth.
5. Perform a skin sensitivity test on every body part that you would like to treat 48 hours
before using the device fully (see chapter "6.2 Skin sensitivity test").
6.2 Skin sensitivity test
1. Connect the mains adapter to the USB-C connection
2. Insert the mains adapter into a suitable socket. The ON/OFF/intensity button
up white continuously. The device is now in standby mode.
3. Briefly hold down the ON/OFF/intensity button
intensity display
cooling indicator lamp
starts.
In the case of facial treatment, the skin sensitivity test should be performed
on an area without hair, for example below the ear or on the side of the
neck.
4. Place the light area
come into full contact with the skin. The skin contact indicator lamp
2
soon as there is sufficient contact with the skin.
5. If the skin contact indicator lamp
a light pulse at level 1. You will see a bright flash and hear a popping sound.
6. Position the skin contact sensor
level by pressing the ON/OFF/intensity button
the trigger button
your skin tone (see the hair and skin colour chart on the back page of these instructions
for use).
Only increase the intensity level if the previous level is not uncomfortable
for you. If intensity level 1 is uncomfortable for you, do not increase the
intensity level.
7. If you experience an uncomfortable feeling after the flash, reduce the intensity.
8. To end the skin sensitivity test, switch off the device. To do so, press and hold the
ON/OFF/intensity button
only the ON/OFF/intensity button
automatically a few seconds after switching off the device. Wait 48 hours and examine
the treated skin area. If the treated skin surface appears normal (no reaction or only
slight reddening), you can treat the tested skin areas at the intensity level set for the
skin sensitivity test.
1
and skin contact sensor
, a small light (level 1) begins to illuminate continuously in white. The
7
3
also begins to light up white continuously and the ventilation
1
on the skin. Ensure that the light area
5
2
. Do not exceed the maximum permitted/recommended intensity for
6
for 2 seconds. The intensity display
8
8
2
using a dry, lint-
to switch on the device. On the
8
is illuminated, press the trigger button
on another treatment area. Increase the intensity
again and release a light pulse using
8
remains illuminated. The ventilation switches off
35
on the bottom of the device.
9
and skin contact sensor
1
5
7
lights
8
lights up as
to trigger
6
goes out and
Publicidad
