Replacing The Fuse - Absaar S-M Manual Del Usuario

EN

REPLACING THE FUSE

Unplug the power cord from the mains and disconnect the battery clamps from the battery before
replacing the blade-type fuse.
The fuse is visible on the front panel.
Remove the defective fuse (fuse wire broken) and replace it with a fuse with the same amperage.
To remove the fuse, insert a screwdriver into the slot between the fuse and the fuse holder. Use the
screwdriver as a lever.
DO NOT APPLY BRUTE FORCE WHEN REPLACING THE FUSE!
A defective fuse is excluded from the warranty.
A spare fuse is supplied with the device. You can also use standard automotive fuses as replace-
ment fuses.
„ jUMP-START"
jUMP
The charger can support a weak or discharged battery when starting the car engine.
START
• Select the Jump-Start switch position.
• Connect the charger to the battery and to the mains as described in the User's Manual.
• We recommend that you first charge the battery for approx. 10 to 15 minutes.
• Keep the charger connected to the battery and to the mains when starting the engine.
• Start the car engine normally.
• The charger is protected against overload when starting the engine.
Depending on the current load, an automatic circuit-breaker will interrupt the circuit after approx.
10 seconds.
• We recommend that you keep the charger connected to the battery for approx. 10 to 15 minutes
after starting the engine in order to minimise any voltage spikes.
• Jump-start duration is set automatically to 1 to 10 seconds.
After completing the jump-start process a circuit-breaker cuts out automatically. To perform
another jump start, wait for 5 minutes and reset the circuit-breaker.
MADE IN GERMANY
www.absaar.com
15