Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
If countertop board material is ceramic, etc.;
ADJUSTING THE HEIGHT
1) Keep the front feet at the minimum height before and
while positioning the dishwasher into the cabinet cutout.
2) Adjust the front foot level with a slot screwdriver to
stabilize the dishwasher and raise it to the enclosure
height.
3) Adjust the rear foot level with a Phillips screwdriver to
balance and raise the dishwasher to the enclosure
height.
NOTE
Make sure the dishwasher is plumb and
note that the dishwasher can be placed
with
a
small
countertop.
For front feet; turning the feet in the
direction of the black arrows with the slot
screwdriver
downwards.
For
rear
screwdriver in the direction of the black
arrows will move the dishwasher feet
downwards.
16
clearance
under
moves
the
dishwasher
feet;
turning
the
If the height of the enclosure is 32 7/16" - 34 7/16" (824mm-
Fig. 12
874mm), use short supports as shown in the figure.
ops.(+50) H= 34 7/16" - 36 3/8" (874mm-924mm)
If the height of the enclosure is above 34 7/16" (874mm),
use long supports as shown in the figure.
STEAM PROTECTION FOIL
Steam will be released when the dishwasher door is
opened during operation of the dishwasher and after
completion of the working cycle. In order to prevent the
resulting steam from collecting and damaging the
underside of the countertop, use a steam protection foil
included in the plastic bag.
Clean the surface with a damp cloth before applying steam
protection to the underside of the countertop.
the
Phillips
Fig. 13
Fig. 14
Publicidad
