Publicidad
Idiomas disponibles
Idiomas disponibles
BM 1609929C87 3/03
3/10/03
WHEEL GUARD INSTALLATION
Wheel guard must be
WARNING
!
attached when using disc
grinding wheels. Always keep wheel guard
between you and your work while grinding.
The position of the guard can be adjusted in
30° increments as necessary to ac-
commodate the operation being performed.
To attach wheel guard DISCONNECT tool
from power source.
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded
spindle for mounting accessories. Always
use the supplied lock nut (and backing
flange) that has same thread size as spindle.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Place BACKING FLANGE and GRINDING
WHEEL on the spindle. Thread on the lock
nut and tighten nut using the supplied lock
nut wrench, while holding the spindle lock in.
TO REMOVE: Reverse procedure.
GRINDING
WHEEL
3:50 PM
Page 7
Assembly
Position the guard on spindle neck so the
two arrows line up. Press guard onto spindle
against the force of the spring and rotate
guard 90° either direction until it clicks in
place, then adjust guard.
TO ADJUST GUARD: depress guard release
button, rotate guard to desired position,
release button and let it click into place.
TO REMOVE GUARD: depress release
button, rotate guard until arrows line up, and
lift guard off the spindle neck.
SIDE HANDLE
The side handle used to guide and balance
the tool can be threaded into the front housing
on either side of the tool, depending on per-
sonal preference and comfort. Use the side
handle for safe control and ease of operation.
SPINDLE
BACKING
FLANGE
LOCK NUT
-7-
SPINDLE
WHEEL
GUARD
BACKING
FLANGE
GRINDING
WHEEL
LOCK NUT
Publicidad
