Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Make sure the ironing board is stable before using it. Make sure that the place for the steam
generator has adequate load strength (a generator with a full water tank weighs around 5 kg).
It is not recommended to use boards made from chipboard.
STEAM IRONING
CAUTION! The iron shoots a lot of hot steam! Risk of scalding!
1. Fill in the water tank as described in the "Getting ready" chapter.
2. Connect the device to the mains.
3. Steam ironing is only possible once the device has heated up. Otherwise, water may start pouring
from the nozzles.
4. Wait until the LED stops flashing. Once this happens, the water is sufficiently hot.
5. Us the button (5) to select the force of the steam shot (5).
6. Keep the steam shot button (8) depressed when ironing.
TIP! The iron features explosive steam shot function for easier ironing of stubborn creases. To
activate the feature, press and keep depressed (for 2 seconds) the steam shot button.
IRONING WITHOUT STEAM
1. Do not press the steam shot button (8) when ironing.
VERTICAL STEAM IRONING
The iron may be held vertically to iron hanging curtains or garments (jackets, suits, over-
coats).
1. Hold the iron in parallel to the ironed fabrics, several centimetres away, and move it while keeping
the steam shot button (8) depressed.
CAUTION! Never aim the steam at people or animals!
CLEANING AND MAINTENANCE
1. Disconnect the power cord from the mains after use.
2. Wait until the iron and the soleplate cool down.
3. Gently clean with a damp cloth.
4. Use a damp cloth with a non-abrasive, liquid cleaning agent to remove any sediment or dirt from
the iron's soleplate.
CAUTION! Never submerge the iron in water or rinse it under running water.
CAUTION! Do not use metal brushes or any abrasive items. Do not use strong detergents to
clean the iron.
5. Wipe the iron's base with a damp cloth.
SELF-CLEANING
1. Refill the water tank as described in the "Filling the water tank" chapter.
2. Place the iron in a safe position, so as to avoid scalding.
3. Connect the device to the mains and switch on with the button (7).
4. Once the iron has heated up (the blue LED stops flashing and stays on), press and keep depressed
(for 3 seconds) the cleaning button (6).
5. The device beeps three times and the LED (1) starts flashing. The cleaning procedure takes about
2 minutes to complete.
6. Once self-cleaning is over, the iron beeps three times.
22
Publicidad
