MPM MTO-07 Manual De Instrucciones página 17

TOASTING
1. Connect the toaster's plug to the mains socket.
2. Set the toasting control know
3. Insert bread into the toaster and then pull the lever
4. When the pre-selected time has been reached, the toaster will switch off automatically. To stop
the toasting process early, press button
THANKS TO THE BREAD CENTERING SYSTEMS, THE BREAD SLICES ARE UNIFORMLY
TOASTED FROM BOTH SIDES.
DEFROSTING / WARMING UP
1. To defrost bread, put it in the toaster, turn the power adjustment knob
lower the lever to put the bread inside the toaster and push the button
8
ommended to set the power adjustment knob
2. Once the defrosting cycle is over, set the power adjustment knob
the lever and press button
8
NOTES
– do not insert crumbled bread that may be blocked inside the toaster.
– do not put grease on the bread for toasting.
– if the bread gets burnet, immediately deactivate the devices!
– to obtain extra toasted bread, repeat toasting.
CLEANING AND MAINTENANCE
1. Before cleaning the device, pull the plug from the mains and wait until the device has cooled down.
2. The toaster's housing may be cleaned with a damp cloth (add a little detergent, if needed).
3. Do not use strong cleaning agents, such as acetone, alcohol or abrasive washing material.
4. Remove bread crumbs from the tray regularly, by sliding the tray, located in the bottom part of the
device. out If the toaster is used often, breadcrumbs should be removed at least once.
CAUTION! Make sure the tray is properly secured, after putting it back.
5. Do not remove any blocked bread from the device with metal utensils, if it is connected to the
mains. If this is needed, first disconnect the plug from the mains and wait until the toaster is cool.
Make sure not to damage the device's internal components.
CAUTION! Do not submerge the device in water or other liquids.
to a position from 1 to 5.
2
8
– STOP, or disconnect the device from the mains.
4
to level 5, when defrosting thick slices of bread.
2
– warming up.
5
down – toasting begins.
into a desired position,
2
– defrosting. It is rec-
6
to the desired position, lower
2
EN
17