Before First Use - weasy CK490 Manual De Usuario

BEFORE FIRST USE

Before first use, carefully unpack the food processor and its attachments and remove any package
material or label or stickers. Clean all the parts except the motor base following the instructions in
CLEANING AND MAINTENANCE. Handle the "S" blade or circle blade assembly with extreme care
as they are sharp.
USING YOUR FOOD PROCESSOR
CHOPPING
1. Firstly assemble the driving shaft into the motor base, make sure it is clipped into position.
2. Place the jar on the motor base and turn it clockwise until it locks into position. Make sure it is
assembled in place correctly, otherwise the appliance will not operate.
3. Insert the "S" blade into the driving shaft in the jar securely.
Then place the prepared chopping food into the jar. The food must be cut into small size firstly
(such as 2cm*2cm*6cm for beef). During chopping, you can add food through the feeding funnel
with the pusher, never using food or finger to push the food into the feeding funnel. When chop
fig, the proportion of fig to honey shall be 380g: 300g and the operation time shall not be more
than 30S.
4. Place the lid onto the jar and turn it clockwise until the tab of the lid clicks into slot in the jar
handle. Make sure it is locked in position correctly, otherwise the appliance will not operate.
5. Connect the appliance to power supply. Press the corresponding speed button according to
your task. You can chop up to 400g of following foodstuff,
Hard substance: cheese, dried fruits, and certain vegetables (carrots, celery...),
Soft substance: certain vegetables (onions, spinach...)
Raw and cooked meat (boned and sliced)
CAUTION: The total operating time should not be more than 30 sec.
6. Press the "OFF" button and unplug the appliance after chopping. Grasp blade by its hub and
remove. Unlock jar by turning it in anti-clockwise away from its base, and lift it off. Empty the
processed food.
CAUTION: The "S" blade is extremely sharp, handle with care.
CLEANING
1. Disconnect the power supply before cleaning.
2. Empty the jar, dismantle all detachable parts and rinse
them in warm soapy water. Extreme caution must be
taken when handling blade as it is very sharp. All the
accessories except motor base are dishwasher safe
components, but the temperature setting shall not
exceed 70℃. Then dry thoroughly.
3. Wipe the outside of base with damp cloth. Never
immerse it in water as electric shock is possible to occur.