ENGLISH
the main body from the vacuuming tube.
-
Hold the dust tank firmly and pull the dust tank release trigger. Then, you will be able to pull
the dust tank outwards to separate both parts.
4. OPERATION
You can use this vacuum cleaner in two different manners:
-
Handheld vacuum cleaner, attaching the accessories directly to the main body.
-
Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
Handheld vacuum cleaner
-
Press the on/off and power switch to turn it on.
-
To set the power level, press the setting button.
-
It will automatically operate in Auto mode. The power level can be adjusted at any moment
by pressing the mode selection button.
-
Press the mode selection button to change the modes AUTO, MAX and ECO.
Upright vacuum cleaner
-
Assemble the vacuuming tube and accessories you want to use as indicated in the
assembly section.
-
Press the on/off and power switch to turn it on.
-
To set the power level, press the setting button.
-
It will automatically operate in Auto mode. The power level can be adjusted at any moment
by pressing the mode selection button.
-
Press the mode selection button to change the modes AUTO, MAX and ECO.
Accessories
This device includes different accessories that allow cleaning different types of surfaces,
objects and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush:
-
Assemble this brush to the upright vacuum cleaner. Jalisco brush is especially designed
to clean hard floors but can be used efficiently to clean any type of surface, such as soft
floors.
-
The brush counts on a protection system that avoids tangles and prevents the device from
being damaged. The brush stops rotating and the device stops operating automatically
when it vacuums big objects or excessive dirt.
52
Accessory for corners:
This accessory has been specifically designed to clean corners, door frames and windows, etc.
You can use them with the handheld or upright vacuum cleaner.
Accessory for furniture:
This accessory is used with the handheld or upright vacuum cleaner, attached previously on
the accessory for corners, and allows cleaning furniture without damaging it and reaching less
accessible dirt in corners.
Accessory for upholstery:
This accessory is used with the handheld or upright vacuum cleaner for deeper cleaning of
upholstered furniture.
Wall bracket. Fig. 7
-
This product includes a wall bracket that allows you to hang the vacuum cleaner from the
wall in an upright position. The same bracket has different accessory holders that allow
storing accessories while not in use.
-
You can install it to the wall using screws.
Warning
It is recommended to install the wall bracket with a height which allows the brush head to
stand on the floor.
Charge. Fig. 8
-
You can charge the device in two different manners. You can charge it directly through the
main body socket, or by removing the battery and charging it separately.
-
It is important to charge it when the battery is low. During charge, the battery indicator
will flash.
-
Once your upright vacuum cleaner is hanging on the wall bracket, connect the cord to a
power supply and let it charge.
-
To charge the battery separately, press the battery release button and separate it from the
main body. Place it on a flat and safe surface and connect it to the power supply.
-
Disconnect the device or the battery from the power socket when the battery indicator is
steady red.
Note
Unplug the device from the electric circuit if you are going to remove the battery from the
vacuum cleaner.
ENGLISH
CONGA ROCKSTAR 890 X-TREME ERGOFLEX
53