Publicidad
Idiomas disponibles
Idiomas disponibles
DEFROSTING THE REFRIGERATOR
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or hoarfrost
form at the back of the refrigerator. This is normal. It is not
necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into the
condensation channel and is conveyed to the compressor from
where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so
that the condensation can run out.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Check that the temperature controller is not in the 0 position.
·
Plug in unit.
·
Use proper voltage.
Cools too frequently
·
The temperature setting is too cool.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Internal temperature not cold enough
·
Check connection of power cord to power source.
·
Plug in unit.
·
Check setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Allow room for air to circulate around unit.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Unusual sounds
·
The appliance is not level. Readjust the adjusting feet and level the unit.
·
The unit is touching a wall or another object. Gently move the appliance.
44
DO91703R
Publicidad
