Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
Control Panel Description
Control panel
Power management step 1
Power management step 1
Switching the hob ON/OFF
To switch the hob on, press the
off. All the cooking zones are deactivated.
If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down.
If within 10 seconds of switching on, no function is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Power indicator display
Selected cooking zone indication
Cooking zone positioning
Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by pressing the corresponding "+" button "0" appears on the display. It is
possible to select the required power level, from min. 0 to max. 9, or booster "P" if available. To increase the power level, push the "+" button. To decrease the power
level push the "-" button.
Deactivation of cooking zones
To switch off the cooking zone, press the corresponding "+" and "-" button for more than 3 seconds.
The cooking zone switches off and, if still hot, the letter "H" appears on the zone display.
Control panel lock
This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Lock function button for three seconds;
an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. To deactivate the control
lock, repeat the activation procedure. The luminous dot goes off and the hob is active again.
The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock.
Timer
The timer can be used to set the cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all the cooking zones.
Select the cooking zone to be used with the timer, press the timer (see figure) and a beep signals the function. The display shows "00" and the LED indication
comes on. The Timer value can be decreased and increased by keeping the slider function "+" and "-" buttons pressed. When the set time has elapsed, an acoustic signal
On/Off
Cooking zone controls and corresponding display
On/Off
Cooking zone controls and corresponding display
button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch
Timer
Control panel lock/Special function/
Power management step 2 and 4
Timer
Control panel lock/Special function/
Power management step 2 and 4
EN9
Power management step 1
Power management step 1
Publicidad
